Skip to content
4 Common Mistakes New Professional Drywallers Always Make

4 Common Mistakes New Professional Drywallers Always Make

Drywalling is good business because people will always need homes to live in and buildings to conduct business out of. If you’ve decided to tap into this market, good for you. But before you get started, check out these four common mistakes new professional drywallers always make so that you don’t run into any problems on the job.

Cutting Your Sheets Too Tight

You don’t want to have the fit of your drywall sheets too tight. You want to make sure you leave enough room to cut off any excess material from the sheet. When hanging vertical drywall, you need to measure all areas of the wall.

These measurements will ensure you get the height and the width before you successfully hang your drywall. For example, if you plan to hang a sheet, and the width at the top is 47 inches, add about ¾ of an inch to that measurement so that you give yourself enough room.

Not Marking the Studs

You can’t hang drywall without knowing where you need to hang it. The worst thing you can do is try to eyeball your measurements and placement. You may think you have a general idea of where the studs need to go, but you don’t.

You need to mark the locations of your framing members before you cover them with drywall. Once you mark where the studs need to go, the screwing process should go over smoothly. Don’t over screw the drywall, though, because this will damage the surface and loosen the hold of the sheet.

Neglecting Frame Support

Never assume you can hang the drywall, and that’s the end of it. Your drywall sheets need proper support by incorporating added backing. Framing the corners and adding the backing for support make it easier to fasten the edge to the wall. If you don’t have adequate support, add an additional 2x4 along the initial framing.

Forgetting To Double Check the Fit

Remember this rule: measure twice and cut once. You never want to measure once and cut twice. This makes for sloppy work. Before you employ your drywall tools and accessories to cut through and fit the sheet, make sure it’s a good fit around the outlets.

Always check the fit around the outlet holes before you fasten in the sheet. Also, trim the opening before you screw the sheet in so that you don’t have to break the drywall around the outlet box. After you measure twice, hold the sheet in place to ensure it’s an exact or close fit, and then fasten the sheet in place.

Here at Timothy’s Toolbox, we have the equipment and materials you need for a successful drywall job. We also have all the insider tips and information. With our assistance, you won’t have to worry about making any of the common mistakes new professional drywallers make. For more information, visit our website.

Previous article 4 Tips for Installing Drywall in Cold Weather

Leave a comment

Comments must be approved before appearing

* Required fields

Compare products

{"one"=>"Select 2 or 3 items to compare", "other"=>"{{ count }} of 3 items selected"}

Select first item to compare

Select second item to compare

Select third item to compare

Compare